Spring is in the mood and the bathing season is incessantly approaching. During the winter, the pool was taken care of, even if we were properly wintering it. It is therefore necessary to prepare it thoroughly. Keep in mind that clean and hygienically safe water is only in a clean pool.
25.4.2017
Spring is in the mood and the bathing season is incessantly approaching. During the winter, the pool was taken care of, even if we were properly wintering it. It is therefore necessary to prepare it thoroughly. Keep in mind that clean and hygienically safe water is only in a clean pool.
Dissolve or release the pool in the spring
It is good to know which
pool you can easily remove and which does not. This is stated in the manufacturer or supplier's instructions for the type of pool. Most
overground pools can be dropped without fear, but there are exceptions. The
recessed pool can not be simply removed. We must first ensure their stability. All other rules apply to concrete pools. Therefore, it is advisable to follow the manufacturer's instructions when discharging and filling the pool.
Cleaning the pool
Leaves, dirt and other dirt need to be removed. If the pool is covered by a canvas over the winter, we will carefully remove it and clean the sail so that when the swimming pool is overlapped, the sail will not pollute the water with debris. Coarse dirt is drawn out of the water with a mesh. Using a sponge and a soft brush, clean the pool walls from dirt.
Clean the bottom of the pool
Clean the pool bottom with a pool vacuum cleaner. Vacuums are hand-operated, semi-automatic and automatic and are capable of thoroughly cleaning not only the bottom but also the pool walls. After cleaning the walls and bottom of the pool, add water.
Water replenishment
Add water to the skimmer level. We measure the pH of the water and adjust the pH and amount of chlorine to the optimum level with the appropriate preparation. For the first time, it is good to use chlorine shock to eliminate all organic impurities. After this treatment, it is necessary to continually filter the water for at least 24 hours.
Checking filter equipment
After filling the pool with water, we also check the filtration system, as well as the wiring that connects the pool to the filtration system. Remember that the sand filler in the filter device should be changed every two years for optimum performance if it is okay, just flush it out. We also clean the hoses leading from filtration to the solar panel. We check for proper tightening of all components, or replace them.
